Given my profession of servicing lenses and the nature of such a precise vocation, I’ve become somewhat compulsive over the past decade. Some might even argue that I’m just downright anal about details. I wouldn’t disagree with that at all. I can’t stand imperfections or flaws. I feel compelled to perfect every minor detail that is within my capacity and even sometimes beyond my capacity, either succeeding or failing, but always learning. This became something of a curse when I started collecting cameras and lenses a while back. I would buy cheap “junk” off of eBay that looked pretty good in the auction photos, but upon arrival, the items were almost always worse than they appeared in the photos, which I came to expect. I couldn’t spend a ton of money on mint condition collectors items as my fiancé would be rather upset if $1000 was used to purchase a 25 year old film camera or lens. So I did my best to find good deals and restore them. It has become quite a painstaking hobby. I consider these dirty, beat-up old cameras and lenses a challenge. I wish I had taken more photos of the equipment I’ve restored prior to their make-over but I really didn’t think much of it at the time. I just wanted my collection to be clean and tidy. The tools and techniques I use on a daily basis have proven to be most valuable to such restorations, allowing me to cleanse, machine, anodize, and essentially re-engineer parts that were otherwise ugly and useless.
One specific item I recently restored was a beat up old Angenieux 1″ f/0.95 prime lens. Equivalent to a 25.4mm, developed in the mid-1950’s, the lens was a breakthrough in aperture speed and was adopted by the Bell & Howell camera system. It uses a somewhat outdated C-mount which can still be found on some surveillance cameras, but not much else. The flange depth of C-mount lenses, at 17.52mm is too shallow even for Micro 4/3 applications. The lens can be mounted, but obtaining infinity focus is almost impossible on anything other than a C-mount camera. On top of the flange depth issue, the lens only produces an image large enough to cover 16mm film, also smaller than Micro 4/3. Regardless, this little gem is a testament to the ingenuity and devotion to the craft that Pierre Angenieux dedicated all those years ago. These lenses can be found in like new condition all over eBay since most of them stayed in their original boxes and weren’t used. This particular lens had quite a bit of exterior scoring and grime jammed in the edges of the barrels. The focus appeared to have been impacted at some point, leaving the focus rotation uneven and rough. On top of that, there appeared to be signs of previous moisture contamination in the form of grey spots around the edges of the elements where it should have been dark black. Most of the engravings had lost their paint and were almost illegible. Certainly not the most devastated lens I’ve seen, but far from good. condition.
I began by completely disassembling the lens. Every lock-ring, element, barrel, and screw were removed. Each part was de-greased and dipped in the ultra-sonic cleanser to remove all the loose particles. I restored full, smooth travel to the focus helix by lapping the focus threads. One of the lock rings that held in the front optics was corroded so I machined the surface down to new material to give it a nice smooth finish, then oxidized the bare aluminum to give it a non-reflective finish. After all the parts were clean and moved freely, I re-lubricated everything with modern Angenieux grease and re-assembled the components. The glass was all cleaned and calibrated/collimated on an Angenieux vertical collimator. I cleaned up the surface of the exterior barrels and re-painted all of the engravings. The lens was better than it was when it came from Angenieux and performed great on my test projector. Another successful restoration to add to my cabinet.